Home > Power Distribution Board (PDB) > Power Distribution Board with BEC 5V & 12V for ZMR250 Multicopter – Clone
Power Distribution Board with BEC 5V & 12V for ZMR250 Multicopter – Clone

Power Distribution Board with BEC 5V & 12V for ZMR250 Multicopter – Clone

Product #: 20586
Price:
Stock:
Out Of Stock
Store:
Robu
 
Reviews:

The Power Distribution Board with BEC 5V & 12V for ZMR250 Multicopter. The HUB distributes power from a battery pack to 4 ESCs, as well as providing two synchronized & regulated DC outputs for powering cameras, servos, video transmitters, LEDs, etc.

Batteries may range from 3S to 6S LiPo, and the BEC input is TVS protected. The HUB also features convenient solder bridge of various voltage for camera & video transmitter.

Note:

This is an open source clone. It has all the features of the original version. These ones are much more economical and affordable than the original ones which are quite expensive. It’s a good option to go for without having to compromise on features and performance. 


Features :

  1. 2oz copper & 4layers PCB.
  2. ESC & Battery solder tabs in pairs
  3. Solder Bridges of various voltage for Camera & VTX.
  4. DC/DC synchronous buck regulator, Efficiency is up to 95%.
  5. TVS(Transient Voltage Suppressor) protection for DC/DC chip.
  6. 5V & 12V Output LED indicators & Short circuit tolerant

 Specification :

  1. General:
    1. Input voltage range (2S6S operation): 7.2 26VDC
    2. Regulated 5V and 12V outputs
    3. LED power indicators ( 5V & 12V outputs )
    4. 4 ESC outputs
  2. ESC outputs:
    1. Continuous current: 20A per output
    2. Peak current (10 seconds/minute): 30A per output
  3. BEC 5V output:
    1. Designed for RC Receivers, Flight controllers, OSD, and Servos.
    2. Voltage: 5.0 +/ 0.1VDC
    3. Continuous current: 3 Amps
    4. Shortcircuit tolerant (10 seconds/minute)
    5. LED (indicates voltage is in regulation, within 10%)
  4. BEC 12V output:
    1. The battery should be 4S~6S LiPo
    2. Standard output designed to power cameras and video transmitters,etc.
    3. Voltage: 12.0 +/ 0.2VDC
    4. Continuous current: 2 Amps (Max.3A 10s/minute)
    5. Shortcircuit tolerant (10 seconds/minute)
    6. LED (indicates voltage is in regulation, within 10%)
  5. CAM & VTX voltage bridge:
    1. 3S operation. choose VCC for 12V camera & 12V VTX, VCC=Battery Voltage.
    2. 4~6S operation, choose 12 for 12V camera & 12V VTX
    3. 3~6S operation, choose 5 for 5V camera
    4. Video pass-through from the CAM pad to the VTX pad
  6. Physical:
    1. Dimensions: 36 x 36mm
    2. Weight: 6g
    3. Mounting holes 30.5mm square spacing

Package Includes:

1 x Power Distribution Board with BEC 5V & 12V for ZMR250 Multicopter


Similar Products